ATF Cooler, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
Replace the ATF pipe with seals after removing.
Clean the ATF cooler before installing.
-- Insert the ATF pipe -1- in the oil pan.
CAUTION:
Leak on the transmission fluid cooler!
- Pay attention to the ATF pipe installation position.
- The side of the pipe with three seals faces the ATF cooler.
-- Insert the ATF cooler -2- on the oil pan.
-- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence. Refer to Figure.
-- Secure the coolant pipe on the transmission. Refer to COOLANT PIPES [For engine(s) CYNB] or COOLANT PIPES [For engine(s) CPNB] .
-- Check the ATF level. Refer to ATF LEVEL, CHECKING .