LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 917 (Exterior Trim System (Service Information)) >> Exterior Equipment >> Name Badges And Emblems >> General Information

General Information

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

CAUTION:
  • Loosened name badges and emblems must be replaced.
  • The vehicle must be at room temperature before installing the name badges and emblems.
  • The adhesive surfaces on the body must be free of dust and grease, as well as free of adhesive residue.
  • Clean the adhesive surfaces using Cleaning Solution :D 009 401 04  .
  • Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air gun.
  • Neighboring components must be protected against temperature effects.
  • After successfully assembling, press on the emblems again with the roller.
scientia non olet · About LEMON Manuals