Overview - Rear Heat Shield

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Heat Shield Exploded View

Courtesy of AUDI OF AMERICA, LLC

Nut
- 2.1 Nm
- Quantity: 2
Heat Shield
- For the driveshaft
- Removing and Installing. Refer to DRIVESHAFT HEAT SHIELD, REMOVING AND INSTALLING .
Bolt
- 55 Nm
- Quantity: 8
Crossbrace
- Removing and Installing. Refer to TUNNEL BRACE, REMOVING AND INSTALLING .
Heat Shield
- For the tunnel rear
- Removing and Installing. Refer to HEAT SHIELD FOR REAR TUNNEL, REMOVING AND INSTALLING .
Nut
- 2.1 Nm
- Quantity: 4
Heat Shield
- For the rear muffler
- Removing and Installing. Refer to REAR MUFFLER HEAT SHIELD, REMOVING AND INSTALLING .
Washer
Spring Clamp/Nut
- Nut: 2.1 Nm
Heat Shield
- For the center of the exhaust system
- Removing and Installing. Refer to CENTER EXHAUST SYSTEM HEAT SHIELD, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to OVERVIEW - FUEL TANK [For engine(s) CPNB] or OVERVIEW - FUEL TANK [For engine(s) CAED, CTUA, CREH, CEUC, CTGE, CREC, CYNB] .
Bolt
- 20 Nm
- Vehicles with center muffler: Tightening specification. Refer to OVERVIEW - MUFFLER [For transmission(s) 0B5, 0CK] [For engine(s) CYNB] or OVERVIEW - MUFFLER [For engine(s) CYNB] or OVERVIEW - MUFFLER [For engine(s) CTGE, CEUC] or OVERVIEW - MUFFLER [For engine(s) CREC, CREH]