Overview - Intake Manifold: Notes
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the air guide pipe
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Seal
- Replacing
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Intake Flap Motor -V157-
- Removing and installing, refer to Intake Flap Motor -V157-, REMOVING AND INSTALLING .
- Seal
- Replacing
- Intake Manifold
- Removing and installing, refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence, refer to appropriate service information. .
- Mounting Pins
- 5 Nm
- For engine cover
- Bracket
- For the connector
- Bolt
- 4 Nm
- Wiring Guide
- Bolt
- 4 Nm
- Seals
- Replacing
- Bracket
- For the EGR Cooler Switch-Over Valve -N345-
- Bolt
- 9 Nm
- Mounting Pins
- For engine cover
- 5 Nm
- Air Guide Pipe
- Bolt
- 9 Nm
- Seal
- Replacing
- Screw-Type Clamp
- Tightening specification, refer to appropriate service information. .
- Air Guide Hose
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- Seal
- Replacing
- Pipe
- For the exhaust gas recirculation
- Bolt
- 9 Nm
- Pipe
- For the exhaust gas recirculation
- Seal
- Replacing
- Screw-Type Clamp
- Tightening specification, refer to step -18- .