Intake Flap Motor -V157-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

-- Remove bolt -3- from center intake manifold bracket.

NOTE:

Ignore item -1-.

-- Remove the bolt -2- for the oil dipstick guide tube.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -1 and 3-.

-- Loosen the screw clamp -2- on the Exhaust Gas Recirculation (EGR) pipe.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Remove the bolts on the left air guide pipe bracket -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Push the air guide pipe -2- to the left side and remove the Intake Flap Motor -V157- -1-.