Overview - Cylinder Block, Transmission Side

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For assembly work, secure the engine on the Engine And Transmission Holder :VAS6095 . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

Fig 1: Cylinder Block, Transmission Side Exploded View

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 60 Nm + 90° turn
- Always replace
Drive Plate
- Check the holes in the flywheel/torque converter for cracks and wear grooves.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
Alignment Pin
Crankshaft
Shaft Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
Sensor Wheel
- For Engine Speed Sensor -G28-
  CAUTION:
  There is a risk of destroying the sensor wheel by magnetic force.
  - Do not place the sensor wheel near magnets (for example inspection lamp base, or speakers).
  - If the drive plate/flywheel or the sensor wheel removes on its own or is replaced, before installing the sensor wheel function must be checked. Refer to SENSOR WHEEL, CHECKING .
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Check sensor wheel. Refer to SENSOR WHEEL, CHECKING .