Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING[For transmission(s) 0BK] .
CAUTION:
There is a risk of destroying the sensor wheel by magnetic force.
- Do not place the sensor wheel near magnets (for example lamp base, speakers).
- If the drive plate/flywheel or the sensor wheel itself was removed or replaced, the sensor wheel function must be checked before installing. Refer to SENSOR WHEEL, CHECKING .
-- Insert the :10-201 to loosen the bolts.
- Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING [For transmission(s) 0BK] or TRANSMISSION, REMOVING AND INSTALLING [For transmission(s) 0BK] .
CAUTION:
There is a risk of destroying the sensor wheel by magnetic force.
- Do not place the sensor wheel near magnets (for example lamp base, speakers).
- If the drive plate/flywheel or the sensor wheel itself was removed or replaced, the sensor wheel function must be checked before installing. Refer to SENSOR WHEEL, CHECKING .
-- Insert the :10-201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate.
- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Loosen and remove the drive plate bolts in a diagonal sequence.
-- Remove the drive plate and sensor wheel.