LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (HVAC System (Heater, Ventilator And A/C)) >> Compressor >> Removal >> Non-Turbo Model

Non-Turbo Model

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform compressor oil return operation. < Ref. to PROCEDURE , Compressor Oil. >
  2. Turn the A/C switch to OFF and stop the engine.
  3. Using the refrigerant recovery system, discharge refrigerant. < Ref. to PROCEDURE , Refrigerant Recovery Procedure. >
  4. Disconnect the ground cable from battery.
  5. Remove the V-belts. < Ref. to REMOVAL , V-belt. >
  6. Remove the bolts and remove the V-belt cover bracket.
    Fig 1: Locating V-Belt Cover Bracket Bolts
    G07666469Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector and terminal from generator.
    Fig 2: Locating Generator Connector And Terminal
    G07666470Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the compressor connector and clip, and move the generator harness to the right.
    Fig 3: Moving Generator Harness To Right
    G07666471Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the bolt and remove the low-pressure hose and high-pressure hose.
    CAUTION: Seal the disconnected hose with a plug or vinyl tape to prevent foreign matter from entering.
    Fig 4: Locating Low-Pressure Hose And High-Pressure Hose Bolts
    G07666472Courtesy of SUBARU OF AMERICA, INC.
  10. Loosen the generator bracket bolts.
  11. Remove the bolts and remove the compressor.
    Fig 5: Locating Compressor Bolts
    G07666473Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals