Blower Resistor (Manual A/C Model): Inspection
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the blower resistor connector.
- Check the resistance between blower resistor terminals.
Courtesy of SUBARU OF AMERICA, INC. TERMINAL REFERENCE CHART
| Terminal No. |
Standard |
| 4 and 3 |
Approx. 0.43 Ω |
| 4 and 2 |
Approx. 1.03 Ω |
| 4 and 1 |
Approx. 3.0 Ω |
- Replace the blower resistor if the inspection result is not within the standard value.