Rear Hub Unit Bearing: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Aligning with the mounting hole of the rear brake back plate, temporarily tighten the rear hub unit bearing to the rear housing.
CAUTION:
- Be careful not to damage the magnetic encoder.
- Do not get closer the tool which charged magnetism to magnetic encoder.
  
  Fig 1: Front Hub Unit Bearing And Magnetic Encoder
  Courtesy of SUBARU OF AMERICA, INC.
Tighten the four bolts of the rear housing.

Fig 2: Bolts Of Rear Housing
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

65 N.m (6.63 kgf-m, 47.9 ft-lb)
Tighten the new axle nut temporarily.
CAUTION: Use new axle nuts.
Install the rear disc rotor.
Install the disc brake caliper on the rear housing.
Tightening torque:

66 N.m (6.73 kgf-m, 48.7 ft-lb)
Install the brake hose bracket and rear ABS wheel speed sensor.
Tightening torque:

Brake hose bracket

33 N.m (3.36 kgf-m, 24.3 ft-lb)

Rear ABS wheel speed sensor

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
While pressing the brake pedal, tighten the new axle nuts to the specified torque.
CAUTION:
- Do not install wheel and let it touch the ground before tightening the axle nut. Failure to follow this rule may damage the axle bearing.
- Do not overtighten the nuts as this may damage the axle bearing.
Tightening torque:

190 N.m (19.37 kgf-m, 140.1 ft-lb)
After tightening the axle nut, lock it securely.

Fig 3: Locking Axle Nut
Courtesy of SUBARU OF AMERICA, INC.
Install the rear wheels.
Tightening torque:

100 N.m (10.20 kgf-m, 73.8 ft-lb)