Propeller Shaft: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Insert the sleeve yoke into the transmission and attach center bearing to body.

Fig 1: Bolts Which Hold Center Bearing To Vehicle Body
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

52 N.m (5.30 kgf-m, 38.3 ft-lb)
Align the alignment marks (A), and connect the flange yoke and rear differential.

Fig 2: Alignment Marks On Flange Yoke And Rear Differential
Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

31 N.m (3.16 kgf-m, 22.9 ft-lb)
Install the heat shield cover.
Install the center exhaust pipe.
Install the rear exhaust pipe and muffler.
Lower the vehicle.
Connect the battery ground terminal.