LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Rear Suspension) >> Rear Shock Absorber >> Disposal

Rear Shock Absorber: Disposal

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before handling the shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.
  • Do not disassemble the shock absorber or place it into a fire.
  • Drill a hole into shock absorbers in case of discarding shock absorbers filled with gas.
  1. Place the shock absorber on a level surface with the piston rod fully expanded.
  2. Make a hole into the specified position 30 mm (1.18 in) deep using a drill with 2 - 3 mm (0.08 - 0.12 in) diameter.
    Fig 1: Locating Shock Absorber Drill Dimension
    G07681158Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals