Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the wheel and tire. For additional information, refer to Wheels and Tires .

2.

NOTE: Do not allow the brake caliper and anchor plate assembly to hang by the flexible brake hose or damage to the hose may occur.

Remove the brake caliper anchor plate bolts and position the anchor plate and caliper assembly aside.
- Support the caliper and anchor plate assembly with mechanic's wire.

3.

NOTE: If the brake disc binds on the parking brake shoe, remove the adjustment hole access plug and contract the parking brake shoe.

Remove the brake disc.

Installation

1.

Clean any rust or foreign material from the brake disc and wheel hub.
- Use specified parts cleaner to clean the rear brake disc and hub surfaces.

2.

Install the brake disc.

3.

Position the brake caliper and anchor plate assembly on the wheel knuckle and install 2 new bolts.
- Tighten to tighten to 190 Nm (140 lb-ft).

4.

Install the wheel and tire. For additional information, refer to Wheels and Tires .

5.

Apply the brake pedal several times to verify correct brake system operation.