Rear Brake Hose

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.
Insert the clamp to secure brake hose.

Fig 1: Brake Pipe, Clamp And Brake Hose
Courtesy of SUBARU OF AMERICA, INC.
Install the brake hose bracket.
Tightening torque:

33 N.m (3.36 kgf-m, 24.3 ft-lb)
Install the brake hose to the caliper body using a new gasket.
Tightening torque (union bolt):

18 N.m (1.84 kgf-m, 13.3 ft-lb)

Fig 2: Locating Union Bolt And Brake Hose Bracket Bolt
Courtesy of SUBARU OF AMERICA, INC.
Tighten the flare nut to the specified torque.
Tightening torque (brake pipe flare nut):

15 N.m (1.53 kgf-m, 11.1 ft-lb)
Bleed air from the brake system. < Ref. to PROCEDURE , Air Bleeding . >