LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Automatic Transmission) >> Transmission Mounting System >> Removal >> Transmission Rear CROSSMEMBER And Rear Cushion Rubber

Transmission Rear CROSSMEMBER And Rear Cushion Rubber

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the center exhaust pipe, (non-turbo model) < Ref. to REMOVAL , Center Exhaust Pipe. >
  4. Remove the center exhaust pipe (rear), (turbo model) < Ref. to REMOVAL , Center Exhaust Pipe. >
  5. Remove the heat shield cover.
    Fig 1: Heat Shield Cover
    G07665501Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack under transmission.
    NOTE: Make sure that the support plate of transmission jack does not touch the oil pan.
  7. Remove the transmission rear crossmember.
    Fig 2: Transmission Rear Crossmember With Bolts
    G07665502Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the rear cushion rubber.
scientia non olet · About LEMON Manuals