Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization .

1.

Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass .

2.

Remove the water trough.
1. 1.
  
  Remove the 2 screws.
  - To install, tighten to 1 Nm (9 lb-in).
1. 2.
  
  Remove the water trough.

Courtesy of FORD MOTOR COMPANY

3.

NOTE: When the roof opening panel is removed from the tracks, inspect the tracks for any remaining guides.

Flex the opening shield to remove the guides from the tracks and remove the roof opening panel shield.

4.

To install, reverse the removal procedure.
- Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment .
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .