Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not permanently remove the trailer hitch. The trailer hitch is an integral part of the vehicle frame. Always reinstall the hitch before delivery of the vehicle to the customer. Failure to follow this instruction may compromise vehicle crash integrity and increase the risk of personal injury in a rear end collision.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .
- 4.
Remove the trailer lighting plug.- Position the plug away from the trailer hitch.
- Disconnect the electrical connector.
- Remove the trailer lighting plug.
- 5.
Remove the electrical connector from the trailer hitch and unclip the harness from the retainers on the frame.
- 6.
Remove the 4 trailer hitch side mounting bolts (2 each side).- To install, tighten to 175 Nm (129 lb-ft).
- 7.
Remove the 4 trailer hitch lower mounting bolts (2 each side) and remove the trailer hitch.- To install, tighten to 275 Nm (203 lb-ft).