Wheel and Tire Rotation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure is intended for vehicles equipped with Tire Pressure Monitoring System (TPMS) and different front and rear tire pressures.
- 1.
Remove the wheel and tire assemblies. Refer to Wheel and Tire .
- 2.NOTE: The front tires are shown at the top of the illustration.
Rotate the wheel and tire assemblies as shown.
- Cross the front tires and move them to the rear of the vehicle.
- Move the rear tires (without crossing) to the front of the vehicle.
- 3.
Install the wheel and tire assemblies. Refer to Wheel and Tire .
- 4.
Adjust the tire pressures. Refer to the Vehicle Certification (VC) label located on the driver door jamb.
- 5.NOTE: The tire pressures must be adjusted and the tire pressure sensors must be trained following a tire rotation. Failure to train the sensors will result in a false low tire pressure event, which will cause the TPMS indicator to illuminate.
Train the TPMS sensors. Refer to Tire Pressure Monitoring System (TPMS) .