Fuel Level Sensor G , checking

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Portable Multimeter V.A.G 1526C

GW00000696

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Portable multimeter V.A.G 1526 C

Fig 2: Identifying Connector Test Set V.A.G 1594 C

GW00000525

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connector test set V.A.G 1594 C

Test sequence

Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
.

Fig 3: Removing Cover Bolts For Locking Flange

GW00014428

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unbolt cover for right locking flange - arrows -.

Fig 4: Identifying Right Locking Flange Electrical Harness Connectors

GW00018595

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical harness connector - 1 - at right locking flange.

NOTE:

Ignore - 2 -.

Fig 5: Connecting Hand Multimeter V.A.G 1526 B Between Terminal For Resistance Measurement

GW00018614

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect hand multimeter V.A.G 1526 B between terminal - 2 - and - 3 - for resistance measurement.

Sensor installed	Sensor at lower stop	Sensor at upper stop
Fuel Level Sensor G	295 to 305 Ω	56 to 68 Ω

NOTE:

If measured value is 0 Ω there is a short circuit. If measured value is ∞ Ω there is and open circuit in the wiring.
To check resistance values "tank full" or "tank empty" , the fuel level sensor G must be removed → Fuel Level Sensor G , removing and installing and the floater of the sensor must be placed in upper or lower end position.
With fuel level sensor G removed, the following values are obtained because of the greater deflection of the floater arm:

Sender removed	Sender at lower stop	Sensor at upper stop
Fuel Level Sensor G	295 to 305 Ω	52.7 to 57.9 Ω