Fuel Level Sensor G , removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Observe safety precautions → Safety precautions when working on fuel supply system .
Observe rules for cleanliness → Rules for cleanliness .
CAUTION:
- To remove the locking flange, the fuel tank may only be filled to a maximum of 1 /4 . Drain fuel tank if necessary. Procedure → Fuel tank, draining .
- Observe procedures for disconnecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
- Push cover over battery toward right - arrow 1 - and remove it upward - arrow 2 -.
- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.
- Open fuel filler flap briefly and then close again.
- Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Unbolt cover for right locking flange - arrows -.
- Disconnect electrical harness connector - 1 - at right locking flange.
- Disengage electrical harness connector - 2 - and lay it aside.
CAUTION:
The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.
- Disconnect fuel line - 1 - from locking flange by pressing release button.
- Disconnect ventilation line - 2 - by pressing release buttons.
CAUTION:
Locking flange may only be opened when fuel tank is maximum 1
/4
full. Otherwise, a large amount of fuel will spill out.
- Remove locking ring using wrench T10202.
- Pull locking flange and sealing ring from opening of fuel tank.
- Disconnect electrical connection on inner side of locking flange - arrow -.
- While pressing retaining tab, pull out fuel level sensor G from guide in baffle housing - arrows -.
NOTE:
- To improve clarity, the baffle housing is shown without the fuel tank.