Fuel tank with attachments, assembly overview: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Bracket
- For exhaust system
2 - Carrier plate
3 - Fuel line
- From fuel filter
- To engine
- Do not kink
- To disconnect, press release button on connection piece
4 - Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- Do not kink
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
5 - 2 Nm
6 - Tire protection shield
- For fuel delivery connection
7 - 23 Nm
8 - Overflow hose
9 - Rubber gasket
10 - Circlip
11 - Seal
- Replace if damaged
12 - Cap
13 - Ground (GND) connection
- For discharging electrostatic charge
- Installed position/check requirements Installation position of Ground (GND) connection
- After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approx. 0Ω
14 - Ventilation line
15 - Ventilation line
- From gravity valve to EVAP canister
- To remove, press release ring on EVAP canister
16 - Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- To remove, press release ring on EVAP canister
- Clipped in on fuel tank
17 - Fuel tank
- Removing and installing → Fuel tank with attachments, removing and installing
18 - Spreader clip
19 - 23 Nm
20 - Securing strap
21 - Heat shield
- For fuel tank
22 - 2 Nm
23 - 23 Nm