Fuel Level Sensor 2 G169 , checking
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Portable multimeter V.A.G 1526 C
- Connector test set V.A.G 1594 C
Test sequence
- Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Unbolt cover for left locking flange - arrows -.
- Disconnect electrical harness connector - arrow - at left locking flange.
- Connect hand multimeter V.A.G 1526 C between terminal - 2 - and - 3 - for resistance measurement.
| Sensor installed | Sensor at lower stop | Sensor at upper stop |
|---|---|---|
| Fuel Level Sensor 2 G169 | 275 to 296 Ω | 47 to 65 Ω |
NOTE:
- If measured value is 0 Ω there is a short circuit. If measured value is ∞ Ω there is and open circuit in the wiring.
- To check resistance values "tank full" or "tank empty" , the Fuel Level Sensor 2 G169 must be removed → Fuel Level Sensor 2 G169 , removing and installing and the sensor floater must be placed in upper or lower end position.
- With Fuel Level Sensor 2 G169 removed, the following values are obtained because of the greater deflection of the floater arm:
| Sensor removed | Sensor at lower stop | Sensor at upper stop |
|---|---|---|
| Fuel Level Sensor 2 G169 | 295 to 305 Ω | 45.5 to 48.1 Ω |