Accelerator pedal module with Throttle Position (TP) sensors, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove driver side storage tray →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
.

Fig 1: Checking Electrical Harness Connector For Damage, Corrosion, Lose Or Broken Terminals

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 2 -.
Remove bolts - 1 - and - 3 -.
Remove accelerator pedal module.

Installing

Installation is in reverse order of removal. Note the following:

Install driver side storage tray →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
.

Vehicles with automatic transmission:

On vehicles with automatic transmission, the kick-down function must be adapted if the throttle position sensor or engine control module are replaced → Kick-down function, adapting after replacing gas pedal module or engine control module (ECM) .

Torque specifications

Component	Nm
Accelerator pedal module to pedal mount	10