PINPOINT TEST H : U3000:44, 45, 46, 48, 49 Or 4A

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

H1 CHECK THE SOD-R and SOD-L FOR DTCs

Ignition ON.

Using a diagnostic scan tool, clear the SOD-R and SOD-L DTCs.

Using a diagnostic scan tool, perform the SOD-R and SOD-L self-tests.

Are any U3000 DTCs present?

Yes	For a SOD-L concern, GO to H2.For a SOD-R concern, GO to H3.
No	The system is operating correctly at this time. The concern may have been caused by an intermittent problem.

H2 CHECK FOR CORRECT SOD-L OPERATION

Disconnect and inspect the SOD-L connector.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the SOD-L connector. Make sure it seats and latches correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new SOD-L. Refer to Side Obstacle Detection (SOD) Module .
No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

H3 CHECK FOR CORRECT SOD-R OPERATION

Disconnect and inspect the SOD-R connector.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the SOD-R connector. Make sure it seats and latches correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new SOD-R. Refer to Side Obstacle Detection (SOD) Module .
No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.