Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps may contain installation details.

Expedition

1.

Remove the LH headlamp assembly. For additional information, refer to Exterior Lighting .

Navigator

2.

Remove the front bumper cover. For additional information, refer to Bumpers .

All vehicles

3.

Remove the horn bolt.
- To install, tighten to 35 Nm (26 lb-ft).

4.

Disconnect the electrical connector and remove the horn.

5.

To install, reverse the removal procedure.