Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The power window regulator motor must be initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the vehicle. For additional information, refer to Window Motor Initialization .

1.

Remove the front door trim panel. For additional information, refer to Interior Trim and Ornamentation .

2.

NOTE: There are 2 tabs on the opposite side not shown in the illustration.

Unlock the 4 tabs and remove the window control switch from the door trim panel.

GFD137703

Courtesy of FORD MOTOR COMPANY

3.

Remove the screws and the front door speaker.
- Disconnect the electrical connector.

GFD137706

Courtesy of FORD MOTOR COMPANY

4.

Remove the front door weathershield.

GFD137724

Courtesy of FORD MOTOR COMPANY

5.

Re-connect the electrical connectors to the window control switch.

6.

Lower the window glass to access the 2 window glass clamp bolts.

7.

Loosen the window glass clamp bolts.
- To install, raise the window glass until it stalls in the UP position. Tighten the window glass clamp bolts to 11 Nm (97 lb-in).

GFD137708

Courtesy of FORD MOTOR COMPANY

8.

NOTE: Secure the front window glass in the full UP position.

Secure the front window glass with tape to the front door frame.

GFD137725

Courtesy of FORD MOTOR COMPANY

9.

Position the interior door handle aside.
1. 1.
  
  Remove the cable conduit fitting from the carrier assembly.
1. 2.
  
  Lift upward on the interior door handle retaining bracket and pivot the interior door handle out of the bracket.
1. 3.
  
  Remove the cable from the door handle.

GFD137726

Courtesy of FORD MOTOR COMPANY

10.

Release the crash sensor harness pin-type retainers.

GFD137727

Courtesy of FORD MOTOR COMPANY

11.

Position the front door window regulator harness aside.
1. 1.
  
  Disconnect the electrical connectors.
1. 2.
  
  Release the pin-type retainers.

GFD137728

Courtesy of FORD MOTOR COMPANY

12.

Remove the front window regulator.
1. 1.
  
  Loosen the 2 hanger bolts.
1. 2.
  
  Remove the front window regulator bolts and front top run channel bolt.
  - To install, tighten to 11 Nm (97 lb-in).

GFD137729

Courtesy of FORD MOTOR COMPANY

13.

To install, reverse the removal procedure.
- The power window regulator motor must be initialized whenever the LF/RF (Navigator) or LF (Expedition) window regulator is removed from the vehicle. For additional information, refer to Window Motor Initialization .