Driveshaft Universal Joint - Single Cardan: Assembly

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: U-joint service kits are to be installed as complete assemblies only. Do not use components from other U-joints.

1.

Clamp the C-Frame and Screw Installer/Remover in a vise.

Courtesy of FORD MOTOR COMPANY

2.

Install a new bearing cup.
- 1.
  
  Start a new bearing cup into the driveshaft yoke.
- 2.
  
  Position a new spider in the driveshaft yoke.
- 3.
  
  Install the driveshaft into the C-Frame and Screw Installer/Remover.
- 4.
  
  Press the bearing cup below the yoke surface.

Courtesy of FORD MOTOR COMPANY

3.

Remove the driveshaft from the C-Frame and Screw Installer/Remover and install the snap ring.

Courtesy of FORD MOTOR COMPANY

4.

Repeat the previous steps to install the remaining bearing cups.

5.

NOTE: Do not strike the bearings. If binding, strike the yoke with a brass or plastic hammer.

Check the U-joint for freedom of movement.

Courtesy of FORD MOTOR COMPANY