Rear Door: Installation
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Put a wooden block on jack and place the rear door on that.
- Apply grease to the moving part of door hinges.
- Install the rear door to upper hinge and lower hinge adjusting by jack.
- Tighten bolt of door checker.
- Connect door harness connector.
Tightening torque: Refer to "COMPONENT" of "General Description". < Ref. to REAR DOOR , COMPONENT, General Description. >
- Install while paying attention to make a uniform clearance around the rear door panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description". < Ref. to SPECIFICATION , General Description. >