Oil Pump, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Make sure both alignment bushings for centering the oil pump are in there.

-- Guide the oil pump chain sprocket into the drive chain and install the oil pump.

CAUTION:

Danger of causing damage to the engine.

The following procedure must be observed otherwise the chain tensioner spring does not spring into the installed position:

-- Pull the chain tensioner spring with the Elbow Assembly Tool T10118 in direction of -arrow- and remove the Chain Tensioner Locking Tool T40265.

Fig 1: Identifying Chain Tensioner Spring, Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

-- Insert the new oil baffle and attach it.

NOTE:

There are plastic ribs on the oil baffle that deform permanently when tightening. The plastic ribs ensure the oil baffle is not loosen and does not rattle. Because of this, always replace the oil baffle.

-- Install the oil pan lower section, refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

-- Fill the engine oil and check the oil level, refer to ENGINE OIL LEVEL, FILLING AND CHECKING .

Tightening specifications

Refer to OVERVIEW - OIL PAN/OIL PUMP