Engine Oil Cooler, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the gaskets and seals.

-- Install the engine oil cooler -3- with a new seal -2-.

Fig 1: Identifying Oil Cooler, Bolts And Seal

Courtesy of AUDI OF AMERICA, LLC

-- Install the accessory assembly bracket, refer to AUXILIARY COMPONENTS BRACKET, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill the coolant pump, refer to COOLANT, DRAINING AND FILLING, NON-HYBRID VEHICLES => Filling or COOLANT, DRAINING AND FILLING, HYBRID VEHICLES => Filling .

-- Fill the engine oil and check the oil level, refer to ENGINE OIL LEVEL, FILLING AND CHECKING .

Tightening specifications

Refer to OVERVIEW - OIL FILTER/OIL PRESSURE SWITCH