Overview - ATF System
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of Causing Damage to the Transmission.
- Do not start the engine when there is no ATF in the transmission or if the ATF pan has been removed.
NOTE:
Always replace the Mechatronic unit if it is dirty or defective.
Clean working conditions for the automatic transmission, refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
General repair instructions, refer to GENERAL REPAIR INFORMATION .
Coat the O-rings and seal with ATF. Other types of lubrication lead to faults in the transmission hydraulics.
- Bolt
- 2.5 Nm + 90°
- Replacing
- Quantity: 13
- Follow the tightening sequence, refer to OIL PAN, REMOVING AND INSTALLING .
- Oil pan to transmission
- ATF Drain Plug
- 12 Nm
- Replacing
- ATF Check Plug
- 9 Nm
- O-Ring
- Replacing
- Atf Pan
- Refer to OIL PAN, REMOVING AND INSTALLING
- Magnet
- Quantity: 2 round magnets, different from illustration
- Ensure full surface contact
- Clean before installation
- Cover Cap
- Inserted in oil pan opening
- Not Installed
- Oil Pan Seal
- Replacing
- Oil Screen
- Refer to OIL SCREEN, REMOVING AND INSTALLING
- O-Ring
- Replacing
- Wiring Harness Connector Clip
- Wiring Harness In Transmission
- Bolt
- 8 Nm
- Following removal and installation instructions, refer to MECHATRONIC, REMOVING AND INSTALLING
- Mechatronic
- Refer to MECHATRONIC, REMOVING AND INSTALLING
- Seal