Clutch Module Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Clutch module -2-, servicing; refer to CLUTCH MODULE .
- A - Alignment Pins
- Not on all vehicles
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.
- B - Alignment Bore
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.CAUTION:
The clutch will not function properly if it is not installed correctly.
- The clutch may have noticeable function problems if the alignment pins for the drive plate -A- are not inside the hole in the clutch module -B-.
- The alignment pins -A- (if equipped) must lock in the hole -B- when attaching the clutch module -2- to the drive plate -1-.
- 1 - Drive Plate
- 6 holes with threaded sleeves
- With needle bearing
- Removing and installing, refer to the appropriate service information
- 2 - Clutch Module
- With transfer plate
- Components: Dual mass flywheel, clutch plate and clutch pressure plate
- Removing and installing, refer to CLUTCH MODULE OVERVIEW / CLUTCH MODULE
- Servicing, refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING
- 3 - Bolt
- Always replace
- 60 Nm
- For mounting the dual flywheel to the drive plate
- Quantity: 6
- Follow the tightening sequence, refer to CLUTCH MODULE TO DRIVE PLATE, TIGHTENING SEQUENCE