After-Run Coolant Pump V51 , removing and installing

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Hose Clamps 3094

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Hose Clamps Up to 25 mm dia. 3094

Fig 2: Drip Tray For VAS 6100, VAS 6208

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drip tray for workshop crane VAS 6208

Removing

CAUTION: Cover cap of coolant expansion tank with rag and open carefully, as hot steam or hot coolant may escape when opening.

Open cap of coolant expansion tank.
Remove upper and lower part of washer fluid reservoir →
- 92 WINDSHIELD WIPER WASHER SYSTEM
- 92 WINDSHIELD WIPER & WASHER SYSTEM for ELECTRICAL EQUIPMENT, CABRIOLET
.

Fig 3: Identifying Electrical Connector, Bolts & Coolant Hoses

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 2 -.
Remove bolts - 3 -.
Clamp off coolant hoses - 1 - and - 4 - with Hose Clamps 3094.
Place Drip Tray for VAS 6100 VAS 6208 below After-Run Coolant Pump V51.

Remove coolant hoses at After-Run Coolant Pump V51.

Installing

Installation is in reverse order of removal, note the following:

NOTE:

Secure all hose connections using hose clamps appropriate for the model type .

Install upper and lower part of washer fluid reservoir →
- 92 WINDSHIELD WIPER WASHER SYSTEM
- 92 WINDSHIELD WIPER & WASHER SYSTEM for ELECTRICAL EQUIPMENT, CABRIOLET
.
Fill with coolant Filling .

Torque specifications

Component	Nm
After-run coolant pump screw clip	5
After-run coolant pump bracket to body	9