Lower part of oil pan, removing and installing: Installing
WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Replace seals.
CAUTION:
Wear safety glasses.
Fig 1: Using Rotating Plastic Brush To Remove Any Remaining Sealant From Oil Pan (Lower Part) And At Upper Part
- Using rotating plastic brush, remove any remaining sealant from oil pan (lower part) and at upper part.
- Clean sealing surfaces, they must be free of oil and grease.
- Cut off nozzle on tube of sealant at front mark (dia. of nozzle approx. 2 mm).
- Apply sealant bead - arrows - on clean sealing surface of lower section of oil pan as shown in illustration.
- Thickness of sealant bead: 2.5 mm.
NOTE:
- Observe the position of the sealant bead at areas indicated with - arrows -.
- Sealant bead must not be thicker than specified, otherwise excess sealant may get into lower section of oil pan and clog strainer in intake tube.
- The oil pan (lower part) must be installed within 5 minutes after application of sealant.
- Position lower part of oil pan and hand tighten all bolts.
- Tighten bolts for lower part of oil pan in 2 stages as follows.
- Pre-tighten all bolts in a diagonal sequence to 5 Nm.
- Tighten all bolts in a diagonal sequence to 9 Nm.
The rest of installation is in reverse order of removal, note the following:
- Install stabilizer bar → 40 - FRONT SUSPENSION .
- Install front coolant pipe → Front coolant line, removing and installing .
- Add engine oil and check oil level → Oil level, checking .
- Fill with coolant Filling .
Torque specifications
| Component | Nm |
|---|---|
| Lower part of oil pan to upper part of oil pan | 9 1) |
| Oil drain plug | 25 |
| Bracket for refrigerant line to upper section of oil pan | 9 |
| Clamp to bracket for refrigerant line | 9 |
|
|