Valve guides, checking

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Dial Gauge Holder VW 387

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Dial gauge holder VW 387

Fig 2: Identifying Dial Gauge VAS 6079

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Dial gauge VAS 6079

Work procedure

Fig 3: Identifying Special Tool - VW 387 Installed

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert valve into valve guide. Due to slight difference in stem dimensions, ensure that only an intake valve is used in intake guide and an exhaust valve in exhaust guide.

Valve stem tip must seal with valve guide.

Determine tilt clearance.

Wear limit: 0.8 mm.

NOTE:

If the valve is to be replaced as part of a repair, use a new valve for the calculation.
If wear limit is exceeded, re-measure using new valves. If wear limit is still exceeded, replace cylinder head.