Cylinder head, component overview: Notes
WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Cylinder head for cylinder bank 2 (left) is shown in illustration.
1 - Cylinder head gasket
- Replacing → Cylinder head, removing and installing .
- Installed location: Part Number, points to cylinder head
- After replacing, change coolant and engine oil
2 - Cylinder head
- Removing and installing → Cylinder head, removing and installing
- Check for distortion Checking cylinder head for distortion
- Reworking dimension Reworking dimension, cylinder head
- After replacing, change coolant and engine oil
3 - Cylinder head cover gasket
- Replace if damaged or leaking
4 - Cylinder head cover
- Removing and installing: Left → Left cylinder head cover, removing and installing , right → Right cylinder head cover, removing and installing
5 - Gasket
- For cap
- Replace if damaged or leaking
6 - Cap
7 - Ignition coil
- Remove with Puller T40039
8 - Special bolt, 9 Nm
- Replace if seal is damaged
- Note tightening sequence → Figure
9 - Camshaft Adjustment Valve 2 N208
10 - 2.4 Nm
11 - O-ring
- Replace
12 - Seal
- Replace
13 - Locking bolt, 35 Nm
14 - 2.4 Nm
15 - Camshaft Adjustment Valve 2 (exhaust) N319
16 - O-ring
- Replace
17 - Cylinder head bolt