Seals for power take-off, replacing

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tools - Seals For Power Take-Off, Replacing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required

Extractor hook T20143
Pressure piece T40051
Pressure piece T40052

Work procedure

Remove air conditioning compressor → 87 AIR CONDITIONING .
Remove power steering pump → 48 - STEERING .

Fig 2: Prying Out Sealing Ring For A/C Compressor Drive Using Pulling Hook T20143/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pry out sealing ring for A/C compressor drive using pulling hook T20143/1.

Fig 3: Prying Out Power-Steering Pump Drive Seal Using Pulling Hook T20143/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pry out power-steering pump drive seal using pulling hook T20143/1.

Fig 4: Driving In Sealing Ring For A/C Compressor Drive Using Thrust Piece T40051

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive in sealing ring for A/C compressor drive using thrust piece T40051.

Fig 5: Driving In Sealing Ring For Power-Steering Pump Drive Using Thrust Piece T40052

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive in sealing ring for power-steering pump drive using thrust piece T40052.

The rest of installation is in reverse order of removal, note the following:

Install power steering pump → 48 - STEERING .
Install A/C compressor → 87 AIR CONDITIONING .