Installing guide frame
WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Replace bolts - 1 to 20 -.
- Tighten bolts for guide frame as follows:
- Tighten bolts - 1 to 10 - to 30 Nm with torque wrench.
- Tighten bolts - 11 to 20 - to 20 Nm with torque wrench.
- Tighten bolts - 1 to 10 - to 50 Nm with torque wrench.
- Tighten bolts - 11 to 20 - to 30 Nm with torque wrench.
- Tighten bolts - 1 to 10 - 90 ° ( 1 /4 additional turn) using a rigid wrench.
- Tighten bolts - 11 to 20 - 90 ° ( 1 /4 additional turn) using a rigid wrench.
- Tighten cylinder block/guide frame sealing surface bolts, - highlighted in illustration but not numbered - , in a diagonal sequence to 9 Nm.