Ribbed belt, removing and installing: Removing

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Quick-Release Fasteners, Screws And Noise Insulation

GW00018071

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove quick-release fasteners - 1 - , remove screws - 2 - and remove noise insulation.

Fig 2: Releasing Ribbed Belt Tension

GW00018392

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Before removing ribbed belt, mark turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the ribbed belt under operating conditions.

To release ribbed belt tension, swing tensioner in direction of - arrow -. Use a lever with ³ /₈ " drive for this.

NOTE:

Ensure lever axle is long enough so that it can be inserted completely in the tensioner.
A suitable lever is, e.g., "Stahlwille 425QR".

Remove ribbed belt.
Release tensioner unit