Electro-Drive Drive Motor, Performing Basic Setting
WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Conditions
The basic setting for the Electro-Drive Drive Motor -V141- must be performed after the following conditions:
- If the Electro-Drive Drive Motor -V141- is replaced.
- If the transmission and Electro-Drive Drive Motor -V141- is replaced.
- If the Electrical Drive Control Module -J841- is replaced, refer to GENERAL INFORMATION .
By performing the basic setting, the rotor position sensor in the Electro-Drive Drive Motor -V141- is introduced and adapted.
Procedure
- All of the test conditions and procedures for the Vehicle Diagnostic Tester must be performed exactly.
-- Select the following menu options under Functions/Component selection in Guided Fault Finding on the Vehicle Diagnostic Tester:
- Body (Rep.-Gr. 01; 27; 50 to 97)
- Electrical Equipment (Rep.-Gr. 01; 27; 90 - 97)
- 51 - Electrical Drive Control Module | J841
- 51 - Electric Drive, Functions
- 51 - Basic Setting (Rep-Gr.93)