Vibration Damper Sealing Ring, Replacing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Crankshaft Seal Installer T10354

Courtesy of AUDI OF AMERICA, LLC

-- Clean the running and sealing surface.

-- Push the seal -arrow- on the Seal Installer - Crankshaft T10354.

The closed side of the seal points to the Seal Installer - Crankshaft T10354.

-- Push the seal -arrow- with the Seal Installer - Crankshaft T10354 on the Tensioning Pins T10531/2 and place on the lower timing chain cover.

Fig 2: Identifying Crankshaft Seal Installer T10354 And Tensioning Pins T10531/2

Courtesy of AUDI OF AMERICA, LLC

-- Additional attach the Press Piece - Gearbox T10375 and tighten the Knurled Nut T10531/4.

Fig 3: Driving Seal In Using Seal Installer - Crankshaft T10354

Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the Seal Installer - Crankshaft T10354. T10354

NOTE:

Replace the vibration damper bolt.

Replace the O-ring.

Further installation is done in the reverse order of removal. Note the following:

-- Install the vibration damper, refer to VIBRATION DAMPER, REMOVING AND INSTALLING .