4-Cylinder 2.0L TFSI Gasoline Engine, Version 1: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING .

-- Remove bolts -1- from the connector strip.

Fig 1: Ignition Coil Wiring Harness

Courtesy of AUDI OF AMERICA, LLC

-- Push connector -2- toward the ignition coil, while at the same time disengaging the locking mechanism and removing the connector.

-- Position the Ignition Coil Puller T40039 on the topmost thick rib -arrow- and remove the ignition coils from the spark plugs in sequence.

Fig 2: Ignition Coil Puller - T40039-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Pay attention to the installed position of the ignition coils.

Be careful to not kink or damage the wiring.

-- Remove spark plugs with Spark Plug Removal Tool VAS 3122B.