Service Interval Display, Resetting With ODIS

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Warning information for the high voltage system:

Procedures for which the ignition needs to be switched on. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .

NOTE:

Reference the maintenance table to see which service channel was reset and which intervals were stored.

-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .

-- Select Diagnosis operating mode and start diagnosis.

-- Select the VIN.

-- Remove V and press Accept to deselect "Work with guided fault finding".

-- Continue following the program procedure.

-- Select Special functions tab.

-- Select the service you want to reset. For example, "17 - Inspection" and start with Perform test... .

-- Continue following the program procedure.