Power Steering, Checking For Leaks And Fluid Level
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Warning information for the high voltage system:
Procedures for which the ignition needs to be switched off. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED OFF .
- Do not let the engine idle.
- Front wheels pointing straight ahead.
-- Remove cover.
-- Clean the dipstick with clean cloth.
-- Install the cap hand-tight and then remove it again.
NOTE:
The fluid level is correct only when the cap is on.
-- Check the fluid level while observing the following guidelines:
- Fluid level test in cold conditions (approx. 20 °C (68 °F)): fluid level must be in -A- range.
- Fluid level test at operating temperature (approx. 80 °C (176°F)): The fluid level must be in the -B- range.
NOTE:
If fluid level is above specified range, then some fluid must be siphoned off.
CAUTION:
If the fluid level is below the specified level, check the power steering system for leaks (repair measure). It is not sufficient just to add fluid.
-- If the power steering system is sealed: fill with power steering fluid. .
-- Screw in cap hand tight.