Mixture Adjustment, Measured Values With ODIS, Reading Out

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The measured values needed will be erased when the DTC memory is cleared.

The DTC memory is not erased.

Procedure:

-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .

-- Select Diagnosis operating mode and start diagnosis.

-- Select the VIN.

-- Remove V and press Accept to deselect "Work with guided fault finding".

-- Continue following the program procedure.

-- Select Control modules tab.

-- Select "01 - Engine electronics" control module and right click to perform the following functions:

Identify control module
Guided functions
01 - Read measured values
"IDE 00597 Long Term Adaptation of Bank 1 Mixture Formation" (Long Term Fuel Trim Bank 1)

And for V6 engines:

"Heated Oxygen Sensor Learned Values, Bank 1 Sensor 1 Partial Load" and
"Heated Oxygen Sensor Learned Values, Bank 2 Sensor 1 Partial Load"

-- Check measured value(s):

NOTE:

If the displayed value deviates by > 15%, then the Fuel Injector Cleaner G17 must be increased by a factor of 4. Refer to FUEL INJECTOR CLEANER G17, ADDING .

CAUTION:

If the measured values continue to deviate even though the amount of additive was increased, then a repair may be needed.