LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Maintenance Procedures) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Diagnostic Data, Gathering >> Diagnostic Data With ODIS, Gathering

Diagnostic Data With ODIS, Gathering

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .

-- Select Diagnosis  operating mode and start diagnosis.

-- Select the VIN.

-- Set V  and press Accept  to select "Work with guided fault finding".

NOTE:

The following describes the control module identification and forwarding to the guided fault finding.

-- After completing the fault finding: Select Diagnosis X  and end the guided fault finding.

-- Send the diagnostic protocol online.

-- Continue following the program procedure until it has been confirmed that the online protocol has been sent.

scientia non olet · About LEMON Manuals