Fan Shroud, Removing And Installing: Installing
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specification, refer to OVERVIEW - RADIATOR/COOLANT FAN .
Install in reverse order of removal. Note the following:
-- Install the air duct on the air filter housing intermediate flange, refer to OVERVIEW - AIR FILTER HOUSING .
-- Install the lock carrier cover (refer to OVERVIEW - LOCK CARRIER ) and noise insulation (refer to OVERVIEW - NOISE INSULATION ) and bumper cover (refer to OVERVIEW - BUMPER COVER ) .
-- Tighten the ATF lines, refer to ATF CIRCUIT .
-- Connect the coolant hose to the coupling, refer to Figure.
-- Fill the coolant, refer to FILLING .
-- Check the ATF level, refer to ATF LEVEL, CHECKING .
-- Install the noise insulation, refer to OVERVIEW - NOISE INSULATION .