Coolant Fan Control Module -J293- / Coolant Fan Control Module 2 -J671-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front noise insulation -1-, refer to FRONT NOISE INSULATION .

Fig 2: Disconnecting Coolant Fan Electrical Connector -1- From Bracket

Courtesy of AUDI OF AMERICA, LLC

WARNING:

There is a risk of injury if the radiator fan turns on by itself.

Disconnect the connectors before working near the fan shroud.

-- Disconnect the coolant fan connector -1- by sliding the retainer back -arrow- and pressing the release down.

-- Free up the electrical wiring harness to the coolant fan control module.

-- Disconnect the connectors -2 and 3-.

Fig 3: Coolant Fan Control Module -J293- & Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and the coolant fan control module -1-.