Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front noise insulation -1-, refer to OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -3- from the Secondary Air Injection Pump Motor -V101-.

Fig 2: Component Location Of Secondary Air Injection (AIR) Pump Motor -V101-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the hoses -1 and 2- for the Secondary Air Injection (AIR).

NOTE:

The installation location is shown with the wheel housing lining removed.

-- Open the hook -arrow A- with a screwdriver -1-.

Fig 3: Removing Fog Lamp Bezel

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air grille -2- from the bumper cover -arrow B-.

-- Remove the bolts -1 and 2- and remove the bumper cover noise insulation toward the rear.

Fig 4: Removing Bumper Cover And Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the secondary air pump.

Fig 5: Identifying Secondary Air Pump And Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installation location is shown with the bumper cover removed.