Overview - Secondary Air Injection System
WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Secondary Air Hose
- O-Rings
- Replace
- Secondary Air Injection Pump Motor -V101-
- Removing and installing, refer to Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING .
- Attach the connector to the bracket
- Check in "Guided Functions " using the Vehicle Diagnostic Tester.
- Bonded Rubber Bushing
- Bracket
- for Secondary Air Injection Pump Motor -V101-
- Nut
- 9 Nm
- Bolt
- 9 Nm
- Seal
- Replace
- Bolts
- 9 Nm
- Vacuum hose
- Right Secondary Air Injection (AIR) Combination Valve
- Checking, refer to SECONDARY AIR COMBINATION VALVES, CHECKING FUNCTION AND LEAKS .
- Removing and installing, refer to RIGHT COMBINATION VALVE, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace
- Secondary Air Injection Sensor 1 -G609-
- Secondary Air Injection Pipe
- Bolt
- 9 Nm
- Left Secondary Air Injection Combination Valve
- Checking, refer to SECONDARY AIR COMBINATION VALVES, CHECKING FUNCTION AND LEAKS .
- Removing and installing, refer to LEFT COMBINATION VALVE, REMOVING AND INSTALLING .
- Vacuum Hose
- Bolts
- 9 Nm
- Seal
- Replace
- Secondary Air Hose
- O-Rings
- Replace
-- Tighten the heat shield bolts -arrows- -1- to 9 Nm.